TEL: +86-510-81153870
Email: info@wxhrf.com
Current location:Home > Matters needing attention in the use of cold bending machine
PRODUCTS
Matters needing attention in the use of cold bending machine
With the continuous development of China's industry, cold bending machine technology has been the same rapid development. Cold bending machinery equipment has become a number of professional factories do not lack of machinery. Then there is also a need to pay attention to the use of cold bending mechanical equipment.
First of all, we should choose a flat surface, put the machine stable, and be able to open the chassis feet so that the machine panel is easy to investigate. Insert the plug on the handheld sensor head into the socket on the panel and tighten it, taking care to locate the gap.
 
Insert one end of the plug of the power cable into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use single-phase three-wire power supply. Then turn over the rear panel of the "POWER switch (POWER SW.)", press the panel "POWER switch (SWITCHING)" key, to" prepare (WARM UP) "green indicator light, the machine can work. Press and hold down the "SETTING BUTTON" key to set the appropriate value, generally between 0.5-2.0 seconds.
 
Put the induction head on the container cover again, press the start button on the handle, then "HEATING" red indicator light, indicating that HEATING, do not remove the induction head, "HEATING" red indicator light off and then remove the induction head.
 
After the green indicator light or the machine buzzer short sound "beep" prompt can be carried out the next container sealing operation. Check the sealing quality, according to different materials, diameter of the container and the production power, appropriate dressing key, so that the sealing quality is good.
 
Cold bending machine needs to pay attention to the following points:
1, check whether the surface of the workpiece is rough.
2, rolling pressure selection is correct, which is very important to the roughness, scale and accuracy of the surface after rolling
Ring.
3, the size of excessive rolling has a great influence on the surface roughness and geometric accuracy.
4, the data soft, plastic, easy to be rolled light.
5. Because the rolling speed has little effect on the surface roughness, we can improve the rolling speed to improve the output power.
6, the number of rolling should not be too much.
7, the size of the feed should be determined according to the diameter of the ball.
8, rolling tools generally have ball bearings, cylindrical rollers, conical rollers, rollers and so on.
CONTACT US Tel: +86-15961895852
Mob: +86-510-81153870
E-mail: info@wxhrf.com
FAX: +86-510-81153873
Add:2-627, XIANGJIANG NORTH ROAD, NEW DISTRICT WUXI CITY, CHINA .214028
Copyright © 2021 Wuxi HRF Science & Technology Co.,Ltd