The working principle of the leveling machine
Each device has a special working principle, and the leveling machine is no exception. Many users have questions about this and often talk about this issue. And this time we will start from this topic.
The working principle of the leveling machine:
The leveling machine is provided with an upper pressing mold and a lower pressing mold. The upper pressing mold is fixed on the push rod of the hydraulic cylinder, and the cylinder block of the hydraulic cylinder is fixed on the support frame. The upper pressing mold and the lower pressing mold are each provided with independent The outlet and inlet of the cooling water path are respectively located on the upper die or the lower die. The ratio of the radius/center distance of at least the first 5 rolls from the entrance of the leveler is the same as that of the traditional leveler, and the ratio of the radius/center distance of at least the next 5 rollers from the entrance of the leveler and curl elimination The machine is similar, and the advantage is that the center distance between the middle rollers of the leveler is increased. It can quickly quench and cool, while avoiding the erosion of impurities on the tool or blank, so as to ensure the quality of the surface and hardness metallographic structure of the tool or blank, and avoid the pollution of cooling oil.
The specific configuration of the equipment can be based on the number of rollers and multiples of the leveling machine according to customer requirements. Generally, there are two layers of 7, 9, 11, and 13 rollers and generally four layers of 11, 13, 15, 17, 19 rollers, and six layers. 17, 19 rolls.
Through the explanation, we also know the principle. In the later use of the leveler equipment, we must also pay attention to maintenance, so that it can be better used by people. Work
TEL: +86-510-81153870 
